ROCK3D is a program for stability analysis of removable blocks on planar rock slopes. It identifies and analyses all the blocks that have formed under each kinematic mode. Once the geometry of the rock blocks has been identified, the bolt forces necessary to reach a required safety factor are calculated. The structural geology data collection is carried out through the introduction of the joint orientations and the co-ordinates of the end points of the joint traces that are visible on the slope surface. The rock slope orientation and the rock mass parameters are also necessary for the evaluation of the safety factors and for the design of the rock bolts. The analysis of the discontinuities is performed through hierarchical and non-hierarchical clustering procedures, that allow one to identify the joint sets. The kinematic modes that could give rise to the formation of removable blocks are determined using the Goodman and Shi "Key Block Theory". The program then calculates the shape of the complex blocks that can be obtained as a union of all the elementary polyhedra that are compatible with the selected kinematic mode, and which are contained within the closed contours identified in the previous stage.
Comments